adding port to load balancer via UI
Hey, I just wanted to let you know, that when ports are added to a load balancer via the UI, the created port does not show in the port list after applying the changes with the "UPDATE LOAD BALANCER" button. After refreshing the page, the added port is correctly listed.
Hey Tom,
Thanks for flagging this for us, we will absolutely take a look at this and release an improvement in the next Portal update.
Hey Tom,
Would you mind providing a little bit of information on your setup, such as what browser you're using. I'm working to reproduce this issue, but the ports seem to be live-updating for me across Chrome, Firefox, and Safari.
And to confirm, the form we are talking about is:
- Load Balancer Modal
- Controllers Tab
- Adding a port in the port list in the left column
- The port does not show up in the column when the "add" button is pressed, only on save/ refresh
Is this reproducible 100% of the time?
Are you experiencing issues with other forms or just this one?
Thanks in advance!
Hey Bryce,
yes, that is the form and the series of actions I was talking about. I am using Brave.
Trying to reproduce the error is unsuccessful for me, too. I think I might have reported this unnecessarily. Sorry about that.
There are slight differences between the load balancer form and most of the other forms I have encountered so far that might have confused me. From what I have seen, most of Cycle's create and destroy buttons use a spinner to indicate that the user is actually completing the desired action. The load balancer form couples the "ADD" and "DELETE CONTROLLER" with the "UPDATE LOAD BALANCER" button.
Thanks for getting back to me!